The Mercon ATF is recommended by the manufacturer for the ZF6 transmission. So if you’re looking for a safe option, go with the Motorcraft Mercon-V automatic transmission fluid. It will help the transmission shift smoothly in all temperatures.
What fluid goes in a ZF6 transmission?
The BoostoMatic ATF ZF 6 is a high graded fully synthetic automatic transmission fluid for ZF 6-speed automatic transmissions.
What kind of oil is used in a manual transmission?
Commonly recommended manual transmission fluid formulations include SAE 80W, 75W-90, 80W-90 and SAE 90. In some cases, a multi-grade engine oil or automatic transmission fluid may be recommended. However, a manual transmission fluid is typically the most optimal for manual transmissions.
What kind of transmission fluid do you use for?
What Transmission Fluid Do I Need?
|Car Make||Transmission Fluid Type|
|Ford Mercury Lincoln||Mercon V|
|Ford (DuratecHE) MAZDA (Europe / Asia)||Mercon LV|
|GM Toyota (pre-2004)||Dexron VI|
|All Honda (except CVT) Acura (except CVT)||ATF DW-1|
How strong is ZF6 transmission?
The ZF S6-650 is a 6-speed manual transmission manufactured by ZF Friedrichshafen AG. It is designed for longitudinal engine applications, and is rated to handle up to 705 newton-metres (520 lbf⋅ft) of torque.
How much transmission fluid does a f350 hold?
Capacities and Specifications – 6.2L
|Automatic transmission fluid (6R140).||17.4 qt (16.5 L)2|
|Transfer case fluid.||1.9 qt (1.8 L)|
|Windshield washer fluid.||Fill as required|
|Fuel tank (incomplete vehicle, middle location).||26.5 gal (100.3 L)|
Can you use motor oil in manual transmission?
Manual transmissions can accept a variety of fluids: regular motor oil, automatic transmission fluid or heavyweight hypoid gear oil.
Can you use gear oil in a manual transmission?
Gear oil, AKA gear lube, is often used in your manual transmission’s gearbox, and you’ll commonly find it in older transfer and differential cases too. … Regardless of what your manual transmission uses, the fluid or oil’s primary function is lubrication—preventing metal-to-metal contact between the meshing gears.
What oil is best for gearbox?
Almasol Pure Mineral Gear Lubricant (401)
Some gearbox manufacturers specify a “pure” or “straight” mineral oil gear lubricant. This means it should not contain chemically active EP additives, although it may still contain various other highly desirable additives.
Can I use dexron 3 instead of ATF 4?
Fina’s product data sheet for its “Dexron-III/Mercon ATF” says it is recommended for “all late model GM…Chrysler and most imported car…automatic transmissions, as well as, (sic) those in Ford vehicles that call for a Mercon fluid.” But, again, a fluid compatible with Dexron III or Mercon is not going to be …
What viscosity is ATF fluid?
Transmission Fluid is essentially thin hydraulic oil. In order to effectively lubricate the delicate parts of the system, the viscosity of the oil is kept low – generally around 0W/5 or 5W/10.
What is transmission fluid made of?
Traditional transmission fluid is made with crude oil, and synthetic transmission fluid is made from specific chemical reactions that make it less likely to oxidize or break down in extreme heat.
How much horsepower can a ZF6 handle?
Pullers claim around 1,000hp is what they are good for. There are lots of factors that contribute to failure. Some of the key parts like input and output shafts can be cryo treated to make them stronger.
Is the ZF6 better than the ZF5?
Registered. the zf5 is a great trans, same as the zf6, the 6 speed has a low gear wich is very nice. allso the 5th gear will lower ur rpm’s a truck with 4:10’s in 6th at 70mph ur rps’s should be at 1200-1500 rpm. both great trans.
Are all ZF6 transmission the same?
The only difference in the ZF6 transmission is between the 7.3L pattern and the newer Mod pattern. Look at the tag on the side of the trans before you buy it. It should say S6-750. Same input shaft???